PARADYNE CORPORATION 7112 T1 DSU/CSU Card Type DSU/CSU Chip Set Unidentified I/O Options Serial port, RJ-45 UTP connector, network interface via RJ-48 connector, power jack, DTE ports (2) Wiring Type RJ-45 Unshielded twisted pair RJ-48 T1 Maximum Data Rate 56Kbps (64Kbps full duplex) Data Modulation Protocol LADS Data Bus External [Image] CONNECTIONS Function Label Function Label Power Jack CN1 Network interface via CN5 RJ-48 connector DTE port (25-pin serial CN2 Monitor connector - CN6 port) line in RJ-45 UTP connector CN3 Monitor connector - CN7 line out DTE port (V.35 CN4 connector) DIAGNOSTIC LED(S) LED Color Status Condition OK Green On DSU/CSU power is on OK Green Off DSU/CSU power is off, performing a self test, or detecting a system failure FAIL Red On DSU/CSU is performing a self test, or detecting a system failure FAIL Red Off DSU/CSU is not performing a self test, or detecting a system failure TST Yellow On DSU/CSU is executing a test TST Yellow Off DSU/CSU is not executing a test SIG Green On A recoverable signal is detected on network SIG Green Off Network signal can not be recovered. OOF Yellow On DSU/CSU is detecting an out of frame condition OOF Yellow Off DSU/CSU is not detecting an out of frame condition ALM Yellow On DSU/CSU has detected an alarm condition on network ALM Yellow Off DSU/CSU has detected an alarm condition on network EER Yellow On Excessive error rate threshold has been exceeded on network EER Yellow Off Excessive error rate threshold has not been exceeded on network TXD Green On Receiving all zeros from the DTE TXD Green Off Receiving all ones from the DTE TXD Green Blinking Data is being transferred RXD Green On Transmitting all zeros from the DTE RXD Green Off Transmitting all ones from the DTE RXD Green Blinking Data is being transferred RTS Green On RTS signal is high RTS Green Off RTS signal is low CTS Green On CTS signal is high CTS Green Off CTS signal is low DTR Green On DTR signal is high DTR Green Off DTR signal is low